Experimental operation of Taber Abrasion Tester

Taber Abrasion Tester is also called Taber Abrasion Tester. Currently, this instrument is mainly used to test the abrasion resistance of leather and plastic, fabric, floor tiles, plywood and other materials.

How does the Taber Abrasion Tester perform the friction test?

The Taber Abrasion Tester relies mainly on rotary grinding, so that it is used to test the abrasion resistance of leather and plastic materials by using different types of friction wheels to rotate on the sample through the test disc.

The specific operation of the Taber Abrasion Tester is as follows:

1. It is necessary to assemble the grinding wheel (abrasive wheel) required for the specimen material before the test according to the relevant test standard of the test material. (Note: the tester will prepare additional fine sandpaper)

2. This step can be cut the standard test piece, and then to be attached to the back of the test piece with double-sided tape (the other side should also be attached to Oh), double-sided tape to remove the paper, weigh the test piece and record the weight, bear paw record to four decimal places.

3. Before opening the test need to confirm the power supply voltage of AC220V, frequency of 50HZ.

4. Before the test lift the test arm of the equipment, and then start the power supply to try to run, we can check from here whether the machine is running properly, and then lift the test arm and vacuum arm, remove the test piece fixing nut and spacer (ring), and then use a wrench to loosen the fixing screw of the fixing ring and pick up the fixing ring that is to complete this step.

5. Next step five, Azhong suggests cutting the prepared fine sandpaper into the model of the test piece in advance, then just put the center hole on the screw and then cover the spacer, then use our nut to fix the fine sandpaper on the disc.

6. After doing the above steps, you need to put on the fixing clip, flatten the sandpaper, and then lock the fixing ring and nut with a wrench.

7. In the test, we can set the number of test revolutions to 50 times (according to different test needs to set their own test revolutions, here Azhong just a small example), set down the test arm and vacuum arm, turn on the power and vacuum cleaner, adjust the air volume, while turning on the motor switch to start running.

8. After sandpaper sanding 50 times, turn off the power, remove the sandpaper according to the opposite steps of 4, 5, 6 and 7, and put it on the test according to the steps of 4, 5, 6 and 7.

9. Set the test revolution number to 1000 times, stick the sand layer on the wheel with plastic cloth, and check whether the double-sided adhesive of the test piece is firm. Put the paper sticker on the test disc, then repeat step 10.

10. When the machine reaches the set number of tests then, it will automatically stop working, this does not require additional attention.

11. To this step, the machine has been tested and automatically stopped. After stopping it, the operator can use a small brush to remove the sand layer on the surface of the leather, here you need to pay attention together with the double-sided tape to remove the test piece oh, and then weigh with precision scales, the same is to record, counting to four decimal places, according to the formula to calculate the test value.

Note: The above operation method can ensure your correct and standardized operation in the testing process, so that Taber Abrasion Tester various functions to run effectively.