How to solve the problem of Programmable Temperature and Humidity Chamber power failure?

Some customers buy the Programmable Temperature and Humidity Chamber and then unplug it and stop using it after the test, in fact, this practice is not scientific. If you have stopped using the Programmable Temperature and Humidity Chamber, you should power it on at least 1-2 times a month, and make the Programmable Temperature and Humidity Chamber run for about 10 minutes each time. Otherwise, if the Programmable Temperature and Humidity Chamber line is clogged or leaking, it will fail when it is used again.

If the Programmable Temperature and Humidity Chamber power failure to do after the 5 measures:

1, first unplug the power cord of the Programmable Temperature and Humidity Chamber, and then use a neat towel to wipe the Programmable Temperature and Humidity Chamber from the inside out, must not have water.

2, moving in the Programmable Temperature and Humidity Chamber that time to pay attention to the vertical and parallel surface to move, as far as possible to reduce the skew, to prevent the refrigeration compressor drag cylinder. As far as possible, the Programmable Temperature and Humidity Chamber should be placed in a naturally ventilated and dry area to avoid direct sunlight.

3, because the Programmable Temperature and Humidity Chamber refrigerant freezing point is very low, so there is no need to worry about the test chamber refrigerant will freeze, and the equipment will be placed in a higher temperature area.

4, some friends think that if the Programmable Temperature and Humidity Chamber is not used for a long time, good to find a plastic bag cover to prevent it from falling soil, this concept is not scientific, because the indoor air contains a certain amount of water, if the plastic bag will be Programmable Temperature and Humidity Chamber cover up, if the plastic bag will be used. and Humidity Chamber cover up, will make the Programmable Temperature and Humidity Chamber absorbed moisture is difficult to emit out, which will cause corrosion of electrical components and damage to metal components on the rust and other reasons!

5, if you want to prevent the equipment from dust, you can use a cotton cloth or tablecloth spread in the Programmable Temperature and Humidity Chamber machine part of the regular cleaning cover cloth can be.

Follow us to get more knowledge: 

1. how to set incubator temperature and humidity?

2. how does temperature and humidity sensor work?