Are You Making These TABER ABRASION TESTER Mistakes?

Taber wear tester is suitable for wear test of leather, leather, cloth, paint, paper, floor, plywood, glass, natural rubber, etc. The method is to cut the test piece with a standard cutter, use a specified type of grinding wheel, and load a certain weight to wear it, take out the test piece after reaching the specified number of revolutions, observe the condition of the test piece after grinding or the weight of the test piece before the test and the weight after the test. weight difference.

TABER ABRASION TESTER Mistakes and repairs:

1. If there is no display when the power is turned on, it means that the power is not connected or the power indicator is damaged. If the power indicator is damaged, just replace the indicator. If there is no power output from the power output terminal, please check the power cord or the power socket.

2. If the power supply is turned on, the power indicator light has an indication, and the machine does not work after pressing the start button, please check whether the relay is disconnected or disconnected. If it is disconnected or disconnected, connect it in time. If the relay is not disconnected, If the relay is damaged, it should be replaced in time.

3. When the motor still does not stop working after the number of times set by the counter is tested, it means (1) the counter is damaged; (2) the counter has not been reset after the number of times set.

4. If the power indicator light is on but the counter has no display, it means that the counter is damaged, and the counter needs to be replaced.

How to operate the equipment correctly and avoid TABER ABRASION TESTER failure problems?

8 operating steps:

1. First take the material with a sampling knife and take a sample.

2. After the sample is taken, stick it on the sample with a special double-sided tape.

3. After pasting, weigh the weight.

4. Cut a hole from the middle of the sample.

5. Put the sample on the wear testing machine and lock it.

6. After locking, press down the weight that needs to be pressed down.

7. After pressing down, set the number of tests to be done.

8. After setting the number of times, turn on the vacuum cleaner and start the test.

If you want to get more questions about the operation skills of TABER ABRASION TESTER, please leave us a message.