Maintenance of fabric tensile testing machines

The fabric tensile testing machines adopts a mechatronics design, mainly composed of a force sensor, transmitter, microprocessor, load drive mechanism, computer, and color inkjet printer.

You may not know much about the maintenance and care of fabric tensile testing machines. Let's share the maintenance and care of the fabric tensile testing machine with you. Let's take a look.

Maintenance and care methods of fabric tensile testing machine:

1. Check the screws in the jaws regularly. If they are loose, tighten them in time;

   
   

2. The sliding surface of the steel plate the lining plate and the dovetail groove surface on the lining plate should be kept clean, and a thin layer of molybdenum disulfide grease should be applied regularly;

   
   

3. Check the transmission of the sprocket regularly. If it is loose, please re-tighten the tension wheel.

Maintenance of fabric tensile testing machine oil source:

1. Regularly check whether there are oil leaks at the main machine and oil source. If oil leaks are found, the sealing ring or combination pad should be replaced in time;

   
   

2. According to the use of the machine and the service life of the oil, regularly replace the oil suction filter and filter element, and replace the hydraulic oil;

   
   

3. When not testing for a long time, pay attention to turning off the power of the main machine.

If the machine is in standby mode, the conversion switch should be turned to the "load" gear, because if the conversion switch is turned to the "fast rewind" gear, the electromagnetic reversing valve is always powered on, which will affect the service life of the device.

Maintenance of fabric tensile testing machine control system:

1. Regularly check whether the connection line on the rear panel of the controller is in good contact. If it is loose, it should be tightened in time;

   
   

2. If the machine is not used for a long time after the test, turn off the controller and computer;

   
   

3. The interfaces on the controller are one-to-one corresponding, and plugging the wrong interface may cause damage to the equipment;

   
   

4. The power of the controller must be turned off when plugging and unplugging the interface on the controller.

The above is the introduction to the maintenance and care of fabric tensile testing machines;

Instrument operators should carefully read and understand the maintenance and care of the equipment, maintain the instrument well, keep the instrument clean, and keep the parts and accessories complete and safe to ensure the normal operation of the instrument.

2024-11-15 13:14