Filter Tester MFP 1000

MFP filter test rigs from Qinsun have already proved themselves many times over all around the world in practical applications in development and quality control.
The MFP filter test rig is a modular filter testing system for flat filter media and small mini-filters. The MFP 1000 can be used to determine:
pressure loss curve on the medium without a dust coating,
fraction separation efficiency, or
burden and fraction separation efficiency during application of the burden
within shortest times – reliably and therefore cost-effectively.
The corresponding aerosol generator can be used depending on the standard or application.
With the aid of the new light scattering spectrometer Promo® 1000, clear and reliable determination of the aerosol concentration and the particle size and therefore a clear determination of the fraction separation efficiency can be ensured.
The largely automated setup of the test sequence together with the clearly defined individual components and the individually adjustable sequence programs of the filter test software FTControl combine to deliver the high reliability of our measurement results.
As a result, filter tests can be performed quickly and easily with the different test aerosols.

Our quality in detail
1. Variable aerosol generation Thanks to the use of different dispersers for dusts, KCl/NaCl, DEHS etc.; shortened measurement times are possible e.g. through increased dust concentration
2. Corona discharge (optional) – adjustable ion stream for different mass flows. Mixed air, adjustable for inflow speeds from 0.05 to 1 m/s. Optional: Transient inflow.
3. Mobile pneumatic filter holder for fast removal and loading of the test rig.
4. Light scattering spectrometer Promo^® system for clear particle measurements in high concentrations of up to 5 • 10⁵ particles/cm³ (SAE Fine) with integrated Windows test rig software. Easy to operate even for untrained personnel thanks to the automated sequence programs for performance of the filter testing. The test rig can be controlled fully automatically.
 
Automation 
The MFP 1000 has integrated mass flow controllers that it uses to control the volume flow; these can be automatically monitored and controlled via the FTControl filter test software. The integrated sensor data such as the volume flow and differential pressure at the filter are also recorded automatically during the filter test.
Measurement of the fraction separation efficiency
 
Clear demonstration of the separation efficiency of your filter medium throughout the entire measurement range from 0.12 µm to 40 µm with the Promo^® system
With its maximum sensitivity, the particle measurement technology can highlight even fine differences in separation efficiency.
Short measurement times of around 2 minutes per separation efficiency measurement thanks to optimized aerosol application
Simple comparison of separation efficiency curves, calculation of mean values also possible
 
Sampling and layout
The strictly vertical layout of the MFP 1000 test system with just one sampling probe delivers clear measurements even for larger particles of up to 40 µm, as sedimentation losses can be ruled out. This enables reliable determination of the separation efficiency across the entire measurement range for all particle sizes.
 
Performance of measurements of the fraction separation efficiency during dust application; pressure loss or measurement time can be pre-selected as the abort criterion
Determination and representation of the pressure loss curve and retention curve in diagram and table form The representation of the particle diameters at 80% and 95% separation efficiency provides additional information.
Comparison of the fraction separation efficiencies during the different burdening steps
Shortening of the measurement times, e.g. through increased dust concentration