Site： Home > News and events 
The characteristic of Anti Synthetic blood penetration tester
The Synthetic Blood Penetration – Splash Resistance test is one of two synthetic blood resistance tests offered by Nelson Labs to determine a product’s ability to act as a barrier to blood-borne pathogens. The Splash Resistance test method challenges medical face masks with a fixed volume of synthetic blood directed at high velocity at the center of the mask.
This test is required by ASTM F2100 and is tested in compliance with ASTM F1862, ASTM F2100, EN 14683, and ISO 26609. Nelson Labs’ highly experienced staff provides a one-stop shop for all ASTM F2100 and EN 14683 testing.
Applicable Standards
ASTM F1862
ISO 22609
ASTM F2100
Sample Specifications
SBP210 : 32 masks are required for each pressure
Study Outline
2 mL of synthetic blood is sprayed through a small cannula onto the surface of the face mask. At the conclusion of the test, the back side of the medical face mask is observed for synthetic blood penetration. Face masks can be evaluated at three different velocities corresponding to a human blood pressure of 80, 120, and 160 mm Hg. If the mask passes at the highest pressure, there is no need to test the mask at a lower pressure. A single sampling plan providing Acceptable Quality Level (AQL) of 4.0% would require that 32 masks be tested and that 29 of the 32 masks pass the test.
The surface tension range for blood and body fluids is approximately 42 – 60 dynes/cm. To simulate the wetting characteristics, the synthetic blood is adjusted to the lower end of this range (40 ± 5 dynes/cm).
2020-07-10 10:54
- Related News
What is the difference between conical and parallel twin-screw extruders?
What is the ISO standard for color fastness?
What is the use of a roundness tester?
The Role of Dust-Proof Robot Protective Clothing
What is the difference between Taber and Martindale abrasion tests?
The Role of Acid- and Alkali-Resistant Protective Clothing in the Chemical Indus
What is the difference between a capillary rheometer and a rotational rheometer?
What is the ASTM standard for abrasion testing?
ISO 105 X12 Colorfastness to Rubbing Test Guide
Working Principle and Standards of the Martindale Abrasion Tester