How to maintain the UV Accelerated Weathering Tester?

UV Accelerated Weathering Tester is mainly suitable for the aging test of non-metallic materials with sunlight resistance and artificial light source. It can simulate the environmental conditions such as ultraviolet, rain, high temperature, high humidity, condensation, darkness, etc. , merged into a loop, and let it automatically execute the complete loop count. In order to better use the UV Accelerated Weathering Tester, you also need to understand its maintenance. 

How to maintain the UV Accelerated Weathering Tester?

1. If the UV aging tester is not working, keep it dry and disconnect the power supply.

2. The wastewater discharge system of UV Accelerated Weathering Tester must be installed in place;

3. When the failure of the ultraviolet light aging test box cannot be ruled out by yourself, please find relevant personnel and do not disassemble it without permission;

4. The sensing device in the studio should not be subjected to strong impact;

5. After the test, drain the water in the tester, and dry the studio and the box.

6. Chemicals are prohibited from contacting this UV Accelerated Weathering Tester; (away from combustibles and explosives);

7. After use, remember to put the plastic cover on to avoid the intrusion of dust. If there is dust, it should be removed in time.

8. If the test box is not used for a long time, it is necessary to carefully check the water source, power supply and various components when using it again, and then start the UV Accelerated Weathering Tester after confirming that it is correct;

9. After each test, take out the sample and clean the UV Accelerated Weathering Tester liner;

10. Operators should wear protective goggles and sheaths. Because ultraviolet radiation has strong hazards to personnel (especially eyes), operators should minimize exposure to ultraviolet rays (contact time should be <1min);

11. UV Accelerated Weathering Tester should be placed in a well-ventilated place (it is recommended to install a ventilation fan to maintain indoor ventilation), and it should not be installed in a dusty place;

12. After use, remember to put the plastic cover on. If there is dust, it should be removed in time to keep the appearance of the box clean and avoid dust from invading the box.

If you want to know more about the maintenance knowledge of UV Accelerated Weathering Tester, please pay attention to the QINSUN tester manufacturer!

2022-03-02 09:57